Using the projector
Digital Projection E-Vision Laser 15000 Series
Setup
▲
Trigger-1
Off
Trigger-2
Off
Infrared Remote
On
IR Code
0
IR Code Reset
OSD Settings
►
Memory
►
Image Latency
Normal
PIC Mute
Laser
No Signal Light Off
Off
The
Projector Controller
software is available for download
from the Digital Projection website,
free of charge.
l
Trigger-1
Choose from
Screen, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, TheaterScope, Source, Unscaled
or
RS232
to
determine what will cause the trigger output to activate.
l
Infrared Remote
Set to
Off
if you wish to disable the remote control.
l
IR Code
The projector and the remote control need a matching IR code: a two-digit number between
00
and
99
.
The default IR code is
00
. This is also a master code, which, if assigned to a remote, will work
regardless of the value assigned to the projector.
l
To assign an IR code for the projector:
Select IR code. Use the UP and DOWN arrow buttons
to change the values.
l
To assign an IR code for the remote
, press and hold the
ADDR
button on the remote until the
On indicator starts flashing. Release the
ADDR
button and while the indicator is still flashing,
enter a two digit address using the numeric input buttons. The indicator will flash three times
quickly to confirm the change.
l
IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the
IR Code
value to 00.
To unassign an IR code from the remote control
, press and hold
ALT
and
ADDR
simultaneously
until the On indicator flashes to confirm the change.
l
OSD Settings
Access this submenu to adjust the appearance and position of the on-screen display.
l
Memory
Access this submenu to save up to four presets containing custom combinations of image settings, or to recall a saved preset.
l
Image Latency
Select
Fast
for improved latency.
Select
Normal
when image corruption occurs. Image corruption (frame tearing) may occur when a high level of warping is applied to the image and fast
latency is selected. See Geometry on page 63 for information about image warping.
l
PIC Mute
Choose from
Laser
and
DMD Blanking
. Select Laser to turn the laser off when PIC Mute activated. Select DMD Blanking to project a black image when
PIC Mute is activated.
l
No Signal Light Off
Choose from
Off
,
5 Min
,
10 Min
and
15 Min
. Choose a time to automatically turn the light source off when no input signal is detected for the duration of the
time period. Choose Off to disable.
Highlight the
UP
arrow at the top of the page and press
ENTER/OK
to go back to the first
Setup
menu page.
Operating Guide
Rev B April 2021
page 89
Notes
