Operating the projector
Digital Projection E-Vision Laser 15000 Series
Infrared reception
40
˚
40
˚
The projector has infrared sensors at the front and rear.
The angle of acceptance is 40°. Make sure that the remote control is within the angle of
acceptance when trying to control the projector.
Switching the projector on
1. Ensure a lens is fitted. Connect the power cable between the mains supply and the projector.
2. Switch on at the switch next to the power connector.
3. Press one of the following buttons:
l
On the remote control, the
ON
button
l
On the projector control panel, the
POWER
button.
The
POWER
indicator begins flashing green and the fans start working. When the flashing stops and the
POWER
and
LIGHT
indicators both light steady green,
the projector is switched on.
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm your choice.
The
POWER
indicator on the control panel will start flashing amber, the system will go out and the cooling fans will run for a short time until the
POWER
indicator goes steady red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect the power cable
from the projector.
Interlock reset
In the event of the laser illumination turning off as a result of an Interlock break:
1. Make sure all interlocks are in place. See Interlock Switches on page 15
2. Turn ON the laser illumination as above
Installation & QuickStart Guide
Rev B April 2021
page 33
Notes
