Administration and maintenance tasks
Mobile device status
Digi XBee Industrial Gateway
48
Status field
Description
Connection duration
Amount of time the current mobile data connection has been active. The
format is N days HH:MM:SS.
Connection error
This status appears only after a connection error occurs. The possible
reasons the previous connection attempt failed are as follows:
n
SIM PIN required
: The SIM PIN must be entered on the Mobile
Configuration page.
n
SIM PIN incorrect
: The SIM PIN entered does not match the
actual one for the SIM.
n
SIM not ready
: No SIM inserted or other SIM problem.
n
Not registered
: The modem did not register with a cellular
network.
n
Dial failed
: Error starting data connection.
n
Authentication failed
: Incorrect login or password entered on
the Mobile Configuration page.
n
Connection timeout
: Connection did not complete.
n
Device reset error
: The modem could not be reset.
n
Device open error
: The modem is malfunctioning.
n
Device config error
: The modem could not be configured.
n
PPP error
: Internal system error.
Disconnect reason
This status appears after a previous connection ends. The possible
reasons the previous connection ended are as follows:
n
User requested
: Initiated by user action.
n
Network disconnect
: Initiated by cellular network or carrier.
n
Carrier loss
: Poor signal or disconnected by network.
n
Connection timer
: Connection did not complete.
n
Receive idle timer
: No data received for configured receive idle
time.
n
Device monitoring error
: Error while monitoring the modem
status. May indicate a malfunctioning modem.
IP address
Internet protocol address of the mobile data interface. You can contact
the device at this IP address if permitted by the carrier.
