Digi XGI-20CZ7-E00-W0, User Manual

Page: 115 / 153

Configure XBee Industrial Gateway GPS static position settings
Digi XBee Industrial Gateway 115
These settings apply to Ping , TCP Connection , and DNS Lookup tests only. Two hostnames may be
configured for the link integrity monitoring test. You can specify hostnames in the form of domain
names or IP addresses. If the first hostname fails to reply, the same test is sent to the second
hostname. The test fails if no reply is received for either hostname. The primary and secondary DNS
names must be fully qualified domain names. Note that the reverse lookup of an IP address is
possible, but that is usually unlikely to succeed in returning a name. You can still use a reverse lookup
to demonstrate the integrity of the mobile connection.
n
Host List 1 : The first hostname to look up.
n
Host List 2 : The second hostname to look up if the first hostname fails to respond.
Test type
Several tests are available. For details about each type, see Link integrity test options .
n
Ping Test
n
TCP Connection Test
n
DNS Lookup Test
n
Device Cloud Connection Test
Link failure action
The action to be performed when a link failure is detected:
n
Reset modem : Reset the cellular modem in the XBee Industrial Gateway device.
n
Reconnect interface : Reconnect the cellular interface.
GPS static position settings
You can use the settings in the GPS status position page to configure GPS support for XBee Industrial
Gateway.
Configuring GPS Static Position settings
To configure GPS Static Position settings, choose one of the following options:
From Remote Manager
1. Click the Device Management tab.
2. Select Advanced Configuration > GPS Static Position .
3. Complete the fields in the GPS Static Position page.
4. Click Save to save your changes.
From the XBee Industrial Gateway web interface
1. Select Configuration > GPS Static Position .
2. Complete the fields under GPS Static Position .
3. Click Apply to save your changes.
GPS Static Position page
The GPS Static Position page allows you to configure the position of a Digi device.
n
Enable use of the static position : Enables or disables the position for a static XBee Industrial
Gateway.