About Digi XBee Industrial Gateway
Safety statements
Digi XBee Industrial Gateway
11
Communications.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables
aux appareils numeriques de la class B prescrites dans le Reglement sur le brouillage radioelectrique
edicte par le ministere des Communications du Canada.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Safety statements
Important Safety Information
CAUTION!
To avoid contact with electrical current, follow all safety items listed below.
n
Never install electrical wiring during an electrical storm.
n
Never install an Ethernet connection in wet locations unless that connector is specifically
designed for wet locations.
n
Use caution when installing or modifying lines.
n
Use a screwdriver and other tools with insulated handles.
n
Wear safety glasses or goggles.
n
Do not place Ethernet wiring or connections in any conduit, outlet or junction box containing
electrical wiring.
n
Installation of inside wire may bring you close to electrical wire, conduit, terminals and other
electrical facilities. Extreme caution must be used to avoid electrical shock from such facilities.
Avoid contact with all such facilities.
n
Ethernet wiring must be at least 6 feet from bare power wiring or lightning rods and
associated wires, and at least 6 inches from other wire (antenna wires, doorbell wires, wires
from transformers to neon signs), steam or hot water pipes, and heating ducts.
n
Do not place an Ethernet connection where it would allow a person to use an Ethernet device
while in a bathtub, shower, swimming pool, or similar hazardous location.
n
Protectors and grounding wire placed by the service provider must not be connected to,
removed, or modified by the customer.
n
Do not touch uninsulated Ethernet wiring if lightning is likely.
