Delta ASDA-B3 Series, User Manual

Page: 351 / 815

Parameters ASDA-B3
8-66
8
P2.008 ■ Special parameter write-in function
Address: 0210H
0211H
Default: 0 Control mode: All
Unit: - Setting range: 0 - 501
Format: DEC Data size: 16-bit
Settings:
Special parameter write-in function:
Code Function
10 Reset all parameters (cycle the power after reset).
20 P4.010 is writable.
22 P4.011 - P4.021 are writable.
30, 35 Save Capture data.
406
Enable forced DO mode.
400
When forced DO mode is enabled, switch back to the normal DO mode.
P2.009 DI response filter time
Address: 0212H
0213H
Default: 2 Control mode: All
Unit: ms Setting range: 0 - 20
Format: DEC Data size: 16-bit
Settings:
When environmental interference is high, increasing this value can enhance the control stability.
If you set the value too high, it affects the response time.
P2.010 DI1 functional planning
Address: 0214H
0215H
Default:
0x0101 (B3-L)
0x0100 (B3-F, E, M)
Control mode: All
Unit: - Setting range:
0x0000 - 0x015F
(last two codes are DI codes)
Format: HEX Data size: 16-bit
Settings:
YX Z U
YX Input function selection Z Input contact: A or B contact
- - U Reserved
 YX: input function selection
Refer to Table 8.1.
 Z: input contact: A or B contact
0: set this input contact to be normally closed (B contact)
1: set this input contact to be normally open (A contact)
Note that you can use P3.006 to determine the source of the digital signal, which can be either an
external terminal block or the communication parameter P4.007.