Dell PowerConnect J-SRX100, Hardware Manual, Page: 94 / 158

To configure basic system properties:
1.
In the J-Web interface, select Configure> System properties and select the required
tab and proceed with configuring the other settings. See Table 26 on page 78 through
Table 28 on page 79 for details.
2.
Click one of the following buttons:
•
Click OK to save changes.
•
Click Cancel to cancel your entries and return to the previous page.
•
Click Commit to apply the configuration and other pending changes (if any) and
click Discard to discard pending changes.
3.
Configure an interface as follows:
a.
In the J-Web interface, select Configure>Interfaces
The Interfaces page appears and lists the network interfaces present on the services
gateway.
b.
Under the Interface Name column, click the interface you want to configure (for
example fe-0/0/0).
c.
Under Logical Interfaces , click Add .
d.
Under IPv4 Addresses and Prefixes , click Add .
e.
In the IPv4 Address and Prefix fields, enter an IP address and a subnet mask
f.
Click OK . The configured IP address is included in the Address Prefix column.
4.
Configure the default route as follows
a.
In the J-Web interface, select Configure>Routing>Static routing
b.
In the Static Routing page, click Add .
c.
Add an IP address for Route and Next-hop.
d.
Click OK . The configured IP address is included in the Static Routing page.
5.
Configure basic security zones and bind them to traffic interfaces.
a.
In the J-Web interface, under the Configure tab, navigate to Security > Zones
b.
Under Security Zone, click Add .
c.
Enter a name for the zone in the Zone Name field.
80
PowerConnect J-SRX100 Services Gateway Hardware Guide