Dell PowerConnect J-SRX100, Hardware Manual, Page: 57 / 158

Figure 7: Hanging the J-SRX100 Services Gateway in a Rack
J-SRX100
J-SRX100
5.
Have a second person install a mounting screw into each of the two aligned holes.
Use a number-3 Phillips screwdriver to install the mounting screws.
6.
Install the second screw in each side of the rack-mount tray.
7.
Verify that the mounting screws on one side of the rack-mount tray are aligned with
the mounting screws on the opposite side and that the tray is level.
Installing the J-SRX100 Services Gateway in a Non-Telco Rack
The J-SRX100S and J-SRX100SU models can be installed in a non-telco rack. Use the
following installation procedure to install the device in a non-telco rack.
Use the cage nuts provided with your rack installation kit for non-telco, square-hole racks
that do not have threaded holes. Cage nuts are installed on the inside of the rack-mounting
flanges with either the cage-nut-insertion tool or a flat-blade screwdriver.
Step 1 — Attaching/Installing the Cage Nuts to the Non-Telco Rack Using a
Cage-Nut-Insertion Tool (Method 1)
To install the cage nuts using a cage-nut-insertion tool:
a. Locate the slot on the rack where you want to mount the device.
b. Insert one edge of the cage nut into the slot from the inside of the rack-mounting
flange.
c. Push the tool through the slot and hook the other edge of the cage nut as shown in
Figure 8 on page 44.
43
Chapter 8: Installing the J-SRX100 Services Gateway