Dell PowerConnect J-SRX100, Hardware Manual, Page: 67 / 158

transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable to the device:
1.
Have ready a length of the type of cable used by the interface.
2.
Insert the cable connector into the cable connector port on the interface faceplate.
3.
Arrange network cables as follows to prevent them from dislodging or developing
stress points:
•
Secure cables so that they are not supporting their own weight as they hang to the
floor.
• Place excess cable out of the way in neatly coiled loops.
•
Use fasteners to maintain the shape of cable loops.
Related
Documentation
Connecting the J-SRX100 Services Gateway to the Power Supply on page 51
•
•
Grounding the J-SRX100 Services Gateway on page 53
•
Interface Cable and Wire Specifications for the J-SRX100 Services Gateway on page 127
•
J-SRX100 Services Gateway Installation Safety Guidelines and Warnings on page 105
Grounding the J-SRX100 Services Gateway
To meet safety and electromagnetic interference (EMI) requirements and to ensure
proper operation, the J-SRX100 Services Gateway must be adequately grounded before
power is connected.
Figure 16 on page 53 illustrates how a grounding cable connects to the services gateway.
Figure 16: Grounding the J-SRX100 Services Gateway
You ground the device by connecting a grounding cable to earth ground and then attaching
it to the chassis grounding points using one M3 screw.
53
Chapter 9: Connecting, Grounding, and Powering On the J-SRX100 Services Gateway