Dell PowerConnect J-SRX100, Hardware Manual, Page: 68 / 158

CAUTION: Before device installation begins, a licensed electrician must
attach a cable lug to the grounding and power cables that you use. A cable
with an incorrectly attached lug can damage the device (for example, by
causing a short circuit).
Table 19 on page 54 lists the grounding components of the J-SRX100 Services Gateway.
Table 19: J-SRX100 Services Gateway Grounding Components
Component Number
Grounding point on the chassis 1
Grounding lug 2
Grounding screw (M3 screw) 3
Table 20 on page 54 lists the specifications of the grounding cable used with the device.
Table 20: Grounding Cable Specifications for the Services Gateway
Specification Grounding Requirement
14 AWG single-strand wire cable Grounding cable
Up to 4 A Amperage of grounding cable
Ring-type, vinyl-insulated TV14-6R lug or
equivalent Grounding lug
To ground the device:
1.
Connect the grounding cable to a proper earth ground.
2.
Verify that a licensed electrician has attached the cable lug to the grounding cable.
3.
Place the grounding cable lug over the grounding point on the middle rear of the
chassis.
4.
Secure the grounding cable lug to the grounding point with the screw as shown in
Figure 16 on page 53.
5.
Dress the grounding cable and verify that it does not touch or block access to the
services gateway components and that it does not drape where people could trip on
it.
NOTE: The device should be permanently connected to ground during
operation.
54
PowerConnect J-SRX100 Services Gateway Hardware Guide