Dell PowerConnect J-SRX100, Hardware Manual, Page: 62 / 158

1.
Place the device on a flat and level surface with the logo facing up.
2.
Position a mounting bracket on each side of the chassis as shown in Figure 13 on
page 48.
Figure 13: Installing the J-SRX100 Services Gateway on a Wall
J-SRX100
3.
Use a number–1 Phillips screwdriver to install the screws that secure the mounting
brackets to the chassis.
4.
If you are using wall anchors to support the chassis, install two pairs of anchors on
the wall with mounting brackets attached.
5.
Have one person grasp the sides of the device, lift it, and position it on the wall.
6.
Have a second person install two pairs of mounting screws through the bracket holes
on either side of the device to secure it to the wall.
7.
Verify that the mounting screws on one side are aligned with the mounting screws on
the opposite side and that the device is level (see Figure 14 on page 49).
48
PowerConnect J-SRX100 Services Gateway Hardware Guide