Dell PowerConnect J-SRX100, Hardware Manual, Page: 81 / 158

Connecting a J-SRX100 Services Gateway to the CLI Remotely
You can connect a J-SRX100 Services Gateway to the CLI from a remote location through
two dial-up modems:
•
A modem that is connected to the console port on the services gateway
• A second modem connected to a remote management device
The modem connection allows you to remotely perform the same console operations
you can perform locally.
Related
Documentation
Performing Initial Software Configuration on the J-SRX100 Services Gateway Using
the CLI on page 74
•
•
Connecting a J-SRX100 Services Gateway to the J-Web Interface on page 63
•
J-SRX100 Services Gateway Software Configuration Overview on page 71
•
J-SRX100 Services Gateway Secure Web Access Overview on page 81
Connecting the Modem at the J-SRX100 Services Gateway End
NOTE: These instructions use Hayes-compatible modem commands to
configure the modem. If your modem is not Hayes-compatible, refer to the
documentation for your modem and enter the equivalent modem commands.
To configure the modem on the services gateway end:
1.
Connect the modem to a PC or laptop computer.
2.
Power on the modem.
3.
From the PC or laptop computer, start your asynchronous terminal emulation
application (such as Microsoft Windows HyperTerminal) and select the
COM port to
which the modem is connected (for example, COM1 ).
4.
Configure the port settings shown in Table 22 on page 67.
Table 22: Port Settings for Configuring the Modem on the Services
Gateway End
Value Port Settings
9600 Bits per second
8 Data bits
None Parity
1 Stop bits
67
Chapter 12: Connecting the J-SRX100 Services Gateway to Management Devices