Dell PowerConnect J-SRX100, Hardware Manual, Page: 79 / 158

NOTE: You must manually configure the IP address for the management
port you are using before you save your initial configuration. When you
save the configuration for the first time, you will lose the connection to
the services gateway if you have not manually configured the IP address.
If you lose the connection through the management interface, you must
connect through the Console port.
Related
Documentation
Performing Initial Software Configuration on the J-SRX100 Services Gateway Using
the J-Web Interface on page 77
•
•
Connecting the J-SRX100 Services Gateway to the CLI on page 65
•
J-SRX100 Services Gateway Software Configuration Overview on page 71
•
J-SRX100 Services Gateway Secure Web Access Overview on page 81
Connecting the J-SRX100 Services Gateway to the CLI
This topic includes the following sections:
• Connecting the Services Gateway to the CLI Locally on page 65
•
Connecting a J-SRX100 Services Gateway to the CLI Remotely on page 67
Connecting the Services Gateway to the CLI Locally
If you plan to use the CLI to configure the J-SRX100 Services Gateway, you must connect
through the console port, as shown in Figure 18 on page 65.
Figure 18: Connecting to the Console Port on a J-SRX100 Services Gateway
65
Chapter 12: Connecting the J-SRX100 Services Gateway to Management Devices