42
ALARM Setup
The alarm menu allows you to adjust which alarms you would like set and adjust the length of time that
the internal buzzer will sound for. This DVR gives you the option to have email alerts sent when motion is
detected. To set up email notifications for motion, please see NETWORKING SETUP - EMAIL TAB.
Motion Tab
CH:
The channel you want motion detection.
Enable:
Enable or disable motion detection.
Area:
Set up the area to be detected by motion.
Sensitivity:
Use a range from (1-8) to detect
object. 1 being the least sensitive and 8 being the
most sensitive.
Show Message:
DVR will display a message on
screen when motion is detected.
Buzzer:
Set the length of the buzzer sounding when
motion is detected (10s, 20s, 40s, 60s).
Send Email:
Send an email when motion is detected.
Full Screen:
When motion is detected on a specific
channel, that channel will be switched to full
screen mode.
Record Channel:
The channel will begin recording
when motion is detected.
Post Recording:
Set the record length after motion
alarm ends (30s, 1 minute, 2 minutes, 5 minutes).
Copy:
Copy your current channel settings to other
channels on the DVR.
To change the status of motion detection for each camera:
1. Select the channel you want to have motion
detection enabled on.
2. Select ENABLE next to the camera you would like
to turn motion detection on/off.
3. Select the drop down menu next to buzzer to set
the length of the buzzer sound.
4. Select the box next to SHOW MESSAGE and Send
Email if you would like these notifications enabled.
5. Select the channels at the bottom by clicking
on them if you would like the channel with
motion to be recorded.
6. Select the POST RECORDING drop down box to
set up the length of recording after the alarm
has ended.
7. Select APPLY to save changes.
DEVICE SETUP
