DayStar Digital TURBO 040, User Manual

Page: 63 / 132

Please read all of this section before you
test the installation.
Testing the
installation
Plug the power cord into the back of the
Macintosh. Press the power sw itch on the back
of the Macintosh. You should hear the custom ­
ary “BONG”. If you do not hear the “BONG”, go
to the next page.
YES! I hear the “BONG”.
1. Turn the power off and remove the power
cord from the Mac.
2. Insert the floppy disk drive cable, hard disk
cable and power connector into the appro­
priate sockets on the motherboard. Reinstall
the disk drive tray by placing the tray back
on its posts. Replace the four screws.
3. Replace the case cover and screw. Attach all
cables you have removed. Now you are
ready to install the software. Please go to
Chapter 9, “Installing the Turbo 040
Software.”
CHAPTER 4
Installing The Turbo 040
-
Macintosh IIx