DayStar Digital TURBO 040, User Manual

Page: 21 / 132

If you are experienced in the installation of the
Turbo 040 in the
Mac
IIx, follow these steps:
1. Back up your hard drives.
2.
Check your hard drives
with A pple’ s Disk
First Aid.
3. Update your hard drives’ driver software
with a version know n to be com patible
with the 68040. If you used a non-Apple for­
matter, make sure that blind transfers are
disabled (see page 118 for more information).
4.
Remove all connectors and the power cord.
5. Remove the Mac IIx cover and disk tray.
6. Put on the anti-static wrist strap.
7. Check to see if the CPU needs socketing
— If it needs a socket, contact DayStar
Technical Support before proceeding.
8.
Remove the CPU
- Use the PGA puller pro­
vided with the adapter.
9.
Install the CPU onto the adapter board.
10.
Install the IIx Adapter Board-
Align the
Adapter over the em pty CPU socket. Press
above the socket until the board is seated.
11. Connect the Turbo 040 to adapter board.
12.
Test the installation
- Attach the pow er
cord. Restart the Mac IIx. Listen for the cus­
tomary “BONG”, then turn off.
13. Replace the disk tray, cover
and make
sure all cables are properly connected.
14.
Install QuadControl software
- Boot the
Mac, insert the DayStar disk and copy the
QuadControl file to the System Folder.
15.
Restart the Mac
- If any problem s occur,
see the troubleshooting section at the end of
Chapter 9.
Q uick
installation
referen ce
for the
M ac IIx
CAUTION:
It is possible
that the pro­
cessor is sol­
dered to the
motherboard
and that the
unit must to
be sent to
DayStar for
socket instal­
lation. If you
are not expe­
rienced at
removing pro­
cessors, follow
the detailed
instructions
in Chapter
NOTE:
An adapter is
required for
installing the
Turbo 040
into the Mac
IIx. The
adapter IIx
must be part
#
000339.
Earlier mod­
els did not
support the
Turbo 040.
CHAPTER 1
Getting Started
19