Profiler User Guide
2-27
To release the pin in the plug, slide the tool down each side of the
pin as shown below to release the tabs and gently pull the wire/pin
out from the back side of the connector.
To re-install, push the wire/pin into the connector from the other
end.
2.5.7
In-Car Wiring
Next you will install the (harness shown is for a MSD Grid) ignition
controller. This harness goes between the ignition box controller
and the ignition in the case of a MSD Grid and 7720 system. A car
using a magneto can be hooked directly to pins 12 and 13 per the
connector pin-out sheet. When you ordered the Profiler you should
be supplied with the correct harness assembly for your application.
The big Profiler plug will have both
Yellow
and
White
wires
terminated with plugs to match up with the
Yellow
and
White
wires
in this harness, plug them together.
The
Black
and
Red
terminated wires are for the Profiler power. Plug
it into the Profiler Red/Black wires that have a matching plug on the
end.
Davis supplied Ignition
Harness.
Summary of Contents for Profiler
