Datalogic AV500, Product Reference Manual

Page: 68 / 324

ELECTRICAL INSTALLATION
48
AV500 2D CAMERA
AV500 CONNECTOR PANEL
After completing mechanical installation, use this section to properly wire your cameras
for optimal performance in your application. AV500 wiring connections are made to the
connector panel and through the CBX connection box (via the I/O port). In most appli
‐
cations, the cable connections to the barcode reader will include:
AV500 Camera
1. HOST NET – Barcode data to Host
2. IMAGE NET – Configuration, Remote Monitor application or image export
3. POWER – Power connected to AV500 power connector
4. I/O – Provides connection to CBX Connection Box
5. SYNC OUT – AV500 internal data, device network
6. SYNC IN – AV500 internal data, device network
When planning your installation wiring, remember all power connections must be quick-dis-
connect. For PERMANENTLY CONNECTED EQUIPMENT a readily accessible disconnect device
must be incorporated in the building installation wiring. For PLUGGABLE EQUIPMENT the
socket-outlet must be installed near the equipment and must be easily accessible.
To assure no ESD damage will occur, be sure to observe the precautions outlined in the
Introduction to this manual.
Ground the mounting structure to safety ground (protective earth ground (PE)). See section
Grounding for wiring recommendations for safety ground.
If a connector is not in use, it should always be covered with its protective cap.