Datalogic AV500, Product Reference Manual

Page: 81 / 324

FOCUSING DEVICE WIRING
PRODUCT REFERENCE GUIDE
61
CBX100
Please verify that the CBX100 connection box is configured for the AV500 application as
follows:
Reference the image and diagram above:
1. Set RS422HD TERM switch to OFF.
2. Set POWER SUPPLY jumper to FROM DEVICE.
3. Insert jumper wire in pin block from REF to ID+ (one jumper in either block is suffi ‐
cient).
4. Set ID ‐ NET TERM switch to OFF.
5. Set Shield jumper to FILTERED Earth.
6. Set DEVICE CHASSIS GROUNDING to Earth.
7. Set POWER Switch to ON.
In order for a standalone or Master AV500 to initialize properly, it must be connected to a
CBX100. On power-up the AV500 looks for the jumper (item number 3 in the image above)
and will assume the responsibility of provided the SYNC Network IP addresses. Slave units
in an array/tunnel will receive their SYNC Network IP addresses from the Master.
Although multiple AV500 cameras can have a CBX box, only one of the CBX boxes in a multi-
camera system can have the jumper to make it the Master.