Datalogic AV500, Product Reference Manual

Page: 292 / 324

AV500 CALIBRATION
272
AV500 2D CAMERA
• Sync Controller IP (the sync adapter cable must be used):
Open a browser and enter cameras IP address into the browser’s address field. When e-
Genius opens, enter the case sensitive user name (setup) and password (DLAset).
e-Genius Calibration Presets
Before physical calibration is begun, a few settings need to be confirmed or modified in
e-Genius . Your PC’s IP address needs to match the camera system’s IP Address range,
see section “Accessing e-Genius via AV500” on page 57 for information on connecting a
laptop to the AV500.
System Info: Bring Each Camera into the Network
When power is applied to the AV500s for the first time each camera will need to be
brought into the sync network using
e-Genius .
1. From the menu tree, navigate to the Modify Settings | System Info . The System
Info Page opens.
2. From the Action drop ‐ down list, select the Add to Cluster as new.
3. Click Update to add the camera to the This Cluster table.
4. Once each AV500 has been added under This Cluster , its mounting positions will
need to be identified. Click Blink in a camera’s row in the table. That camera’s illu ‐
mination will light.
5. Once the camera has been identified, select its mounting position from the Cam-
era Position drop ‐ down list.
6. Click Update to save the configuration.
Operating Mode
In the menu tree under Modify Settings , navigate to Global Settings | Operating Mode.
The Operating Mode window opens. See section “Modify Settings | Global Settings |
Operating Mode” on page 62 for an explanation of the Operating Mode options.
The following parameters must be set to match the application:
1. Encoder Settings ‐ Encoder Step Settings: Modify Settings | Global Settings |
Operating Mode > Encoder Step. Conveyor speed: Enter the conveyor speed (For ‐
mula:
Max conveyor speed x 1.05)
. This is needed so the AV500 sets the exposure
time parameter during calibration.
2. Trigger Source: Make sure the Trigger Active State is set correctly, To test this, nav ‐
igate to Diagnostics | Device Tracking . Run two boxes through the system. Con ‐
firm that the start and end trigger corresponds to the correct Seq Number.
3. Transmit Point Settings
4. Other Important Application Dependent Parameters:
Your PC’s IP address needs to match the camera system’s IP Address range, see section
for information on connecting a laptop to the system. The Host and Image port IP
addresses may have been changed for your application. Contact your system administra-
tor for changes.