Datalogic AV500, Product Reference Manual

Page: 69 / 324

CONNECTING A PC TO THE AV500
PRODUCT REFERENCE GUIDE
49
Route wiring from the barcode reader’s connector panel through the wiring channels (if
available) on the Datalogic mounting structure when interconnecting cables to other
devices.
CONNECTING A PC TO THE AV500
During initial setup, a PC (laptop) may be connected to the AV500 with an RJ45 cable.
Connect an Ethernet cable from the
HOST NET or IMAGE NET port of the AV500 to the
Ethernet port of your PC. For information on connecting to e ‐ Genius, see “E-Genius” on
page 56.
POWER CONNECTOR PIN-OUT TABLE (CUSTOM POWER
SUPPLY)
A recommended power supply and cabling is available for the AV500 Camera. However,
if your installation requires custom power supply wiring, the pin
‐ outs of the AV500 cam ‐
era power connector are provided below.
SELECTING THE CORRECT CBX CONNECTION BOX FOR YOUR
APPLICATION
As shown in section Typical Connection Block Diagrams , typical applications require a
single CBX connection box to connect the trigger and encoder inputs to the master cam ‐
era. The camera sources power to these devices. Other possible CBX connections are for
digital outputs or a serial host.
• CBX100/CBX500 ‐ used for slave cameras (and as an alternative for master cam ‐
eras). It provides general access to digital input/output signals.
When using an AV500 camera, no power supply is required for the CBX510 connection box.
All power and some communication options are fed to the CBX510 through the scanner’s 17-
pin I/O connector to the CBX510 25-pin connector using the cable provided.
In cases where the AS-I cabling is not used, the alternative CAB-LP-05 cable can be used to
connect the power supply to the scanner. Connect the Brown/White pair to +24 Vdc and the
Blue/Black pair to dc return. Chassis ground needs to be connected. Use cable CS-A1-02
that has 5th ray wire.