DataCard CD800, User Manual

Page: 102 / 114

A-4 CLM Laminator
Inside the Laminator
The CLM laminator has one standard laminator, in the L1 position, with an
optional second laminator in the L2 position. The laminators apply topcoat or
patch overlay material to the card. Topcoat is a continuous film and patch is a
die ‐ cut polyester shape. Both laminators can apply either overlay type. Refer to
"Laminator Overlay Materials" on page A ‐ 6 .
Manual Advance
Knobs
The manual advance knobs move the card through the
laminator to remove it from the system. Use the knobs to
clear a card jam.
L1 Laminator (green
cartridge)
The L1 laminator cartridge holds the overlay material and
applies it to the card.
L2 Laminator (orange
cartridge)
The L2 laminator cartridge holds overlay material and
applies it to the card. The L2 laminator is optional.
Optional Bar Code
Scanner
The bar code scanner reads a bar code printed on
special serialized overlay material and matches it to the
card identification information. Refer to "Serialized
Overlay with Bar Code" on page A-8 .
Laminator Access Door The access door provides access to the L1 and L2
laminators to load supplies or to clear a card jam.
L2 Transport Access
Door
The L2 transport access door replaces the L2 laminator
cartridge if the optional second laminator is not installed.
Open the door to access the laminator card transport.
Laminator
Access Door
Manual Advance
Knobs
L1 Laminator
L2 Transport
Access Door
L2 Laminator
Optional Bar
Code Scanner