Daihen Welbee WB-A350P, Owner'S Manual

Page: 39 / 150

4-5
Chapter 4 Connection
C
ONNECTING THE
W
ELDING
P
OWER
S
OURCE
C
ONNECTION
C
HAPTER
4
4.2.2.1 Precautions for connections for AC TIG welding
When using the welding power source for AC TIG welding, keep the cable as short as possible. If you
really need to use an extension cable, use caution on the following points.
• Bundle both the base metal cable and the torch cable and apply tape on them.
• Straighten the cables as much as possible.
• If you cannot straighten the cables as explained, run the torch cable on the base material.
• When using the welding power source with surplus cables wound, wind them referring to the following
good example.
[Bad example] [Good example]
Do not wind all surplus cables in the same direction.
Wind each cable in the opposite direction to make two
bundles, and pile them.