Daihen Welbee WB-A350P, Owner'S Manual

Page: 106 / 150

S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-46
6.10.2.43
F61: Fine adjustment of electrode formation
Fine adjusts the shape of the electrode tip in the electrode formation function.
Fine-adjust the formation time by the grinding angle of the electrode.
• If the grinding angle is sharp, set to negative.
• If the grinding angle is obtuse, set to positive.
6.10.2.44
F62: Extended cable mode
Sets the welding control for the extended cable when the welding power source is used in AC TIG mode
or AC-DC TIG mode.
Extending or winding the power cable such as the cable (base metal side) and the torch cable will cause
the E-751 error code (Secondary side circuit overvoltage error). In such a case, you may correct the error
by setting this function to "ON" (Extended cable mode).
• [ON]: Extended cable mode
Set to "ON" as a guide when the length of the extension cable exceeds 30 m round-trip. When set to "ON",
the "AC WAVEFORM" LED flashes.
• [OFF]: Standard mode
This is the standard AC TIG mode and AC-DC TIG mode.
NOTE
• When the extended cable mode is set to "ON", the AC frequency setting range is limited
within 30 to 100 Hz. Depending on the condition of the output cable, current may not be
output as specified in comparison with the standard mode.
• If the output cable is extended, the high frequency start voltage is attenuated and the
arc startability is impaired depending on the routing of the cable. If welding does not
start in the high frequency start method, switch to the lift start method.
6.10.2.45 F77: Welding result control function identification numbers
Sets the identification numbers of welding power source when using welding result control function.
The identification number set in this function become the part of file name when backing up the data of
welding result control function. ( 7.3.4
-
Welding Result Control Function)
• Setting range of identification number: 1 to 999.