Daihen Welbee WB-A350P, Owner'S Manual

Page: 112 / 150

W
ELDING
R
ESULT
C
ONTROL
F
UNCTION
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
7-4
7.2 Welding Result Control Function
This section explains about the welding result control function. The function enables the management of
the items below.
Details of control contents ( 7.2.2
-
Details of welding control items)
7.2.1 Setting welding result control function
This section explains how to set the welding result control function.
1.
Press and hold the WELD MONITOR key for one second or more.
Welding control
parameter
Monitor
No.
Initial
value
Setting range Explanation
Number of welding
point
P10 0 - Cumulative number of welding points (number of times)
P11 0 0 to 999 Target value of welding points (number of times)
P12 0 0 to 5
Operation at the time when the target value of welding points
is achieved
Total welding time
P20 0 - Cumulative total welding time (minute)
P21 0 0 to 999 Target total welding time (minute)
P22 0 0 to 5
Operation at the time when the target total welding time is
achieved
Welding monitor
P30 0 - Max. fluctuation value of average range monitor (A or V)
P31 100 0 to 100 Current tolerance (+) (%)
P32 100 0 to 100 Current tolerance (-) (%)
P33 100 1 to 100 Welding voltage upper limit value setting (V) (*1)
P34 0 0 to 99 Welding voltage lower limit value setting (V) (*1)
P35 0 0 to 100 WARNING judgment time (second)
P36 0 0 to 2 Operation at the time of WARNING detection
Total operation time
control
P40 0.0 - Cumulative total operation time (hour) (*2)
P41 0.0 - Cumulative total welding time (hour) (*2)
P42 oFF oFF/cLr Clear of control data value (*3)
*1: Upper limit value is controlled not to become under the lower limit value.
*2: Any value smaller than 100 is displayed up to the first digit below the decimal point.
*3: The values in P10, P20, P40 and P41 will be reset by setting P32 to "cLr" to exit the welding control mode.
⇒
The LED of WELD MONITOR key lights up.
⇒
The monitor No. is displayed on the left digital
meter.
⇒
The data value specified for the monitor No. is
displayed on the right digital meter.
A
sec.
Hz
JOB No.
V/
mm
%
Φ
DC NO-LOAD VOLTAGE WARNING
WELD
MONITOR