Daihen Welbee WB-A350P, Owner'S Manual

Page: 102 / 150

S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-42
6.10.2.31 F39/F40: Current display adjustment (Gain/offset)
Set the adjustment value (gain/offset) when the current display value on the left digital meter is different
from the actual current value.
The current value displayed on the digital meter is obtained by software processing of the average value
of outputs; therefore, it may not be consistent with the value indicated on a needle meter, etc. When this
happens, using this function enables to finely adjust the current display value.
• For F39, set gain, and for F40, set offset.
Changing the set value only corrects the display; the output welding current does not change.
• For more information on the adjustment procedure, contact dealer.
NOTE
• Do not carelessly change the setting of this function.
6.10.2.32 F41/F42: Voltage display adjustment (Gain/offset)
Set the adjustment value (gain/offset) when the voltage display value on the right digital meter is
different from the actual voltage value.
The voltage value displayed on the digital meter is obtained by software processing of the average value
of outputs; therefore, it may not be consistent with the value indicated on a needle meter, etc. When this
happens, using this function enables to finely adjust the voltage display value.
• For F41, set gain, and for F42, set offset.
Changing the set value only corrects the display; the output welding voltage does not change.
• For more information on the adjustment procedure, contact dealer.
NOTE
• Do not carelessly change the setting of this function.
6.10.2.33 F43: CAN ID
When multiple welding power sources are connected with a PC monitoring system, set ID for CAN.