10-10
FRONT WHEEL/FRONT FORK/STEERING
●
Be sure that the bead is completely collapsed.
●
In case of the tube type tire, insert the tire lever from
the opposite side of the valve and raise the bead over
the rim.
●
On tubeless tires, insert the tire lever from the valve
side and raise the bead over the rim.
●
Always use a rim protector when using tire levers.
·
To avoid damaging the rim when using the tire lever,
always use rim protectors.
·
Be sure to use motorcycle tire levers.
·
Do not apply the mild detergent solution to the rim
and tire mating surfaces of low pressure tire. Apply
water only.
●
Insert another tire lever at 30~50mm from the first tire
lever and remove the tire from the rim, little by little.
·
Do not try to remove the bead too much at one time.
·
Do not pry against or scratch the bead stopper area
with the tire lever.
●
Repeat the above procedures until half of bead is
removed. Then remove the remaining bead by hand.
●
Remove the tire from the rim.
Summary of Contents for A-FOUR -
