DAELIM A-FOUR -, Service Manual

Page: 151 / 186

14-1
14. IGNITION SYSTEM
SERVICE INFORMATION
GENERAL SAFETY
●
Refer to the malfunction diagnosis when inspecting ignition devices.
●
Because the ignition devices have installed electrical advancer devices, it is impossible to adjust ignition timing.
●
Be careful when handling the ignition devices as they can become easily damaged if dropped or bumped. Also, do not
disconnect or connect the connectors and couplers when the main swtich is turned ON as excessive electric current can
cause damage in the unit. Always perform maintenance work on the ignition devices with the main switch turned OFF.
●
Ignition devices can often appear to be malfuctioning when the couplers or connectors are disconnected. Check these
connections before working on.
●
Use recommended spark plug. Using incorrect spark plug may make the engine run badly or damage the engine.
●
This manual gives explanations on inspections to receive peak voltage. As inspections for coil resistance values are also
included, it may be difficult to make a correct determination.
●
Conduct inspection on the main swtich by referring to the wiring diagram continuity chart. ( chapter 16 )
14
SERVICE INFORMATION 14-1
IGNITION DEVICES LOCATION 14-2
TROUBLESHOOTING 14-3
IGNITION SYSTEM INSPECTION
(PEAK VOLTAGE MEASUREMENT)
14-4
IGNITION COIL 14-5
EXCITE COIL INSPECTION 14-6
PULSE GENERATOR INSPECTION 14-6
IGNITION TIMING INSPECTION 14-7
CDI UNIT 14-7
SIDE STAND IGNITION
CUT-OFF SWITCH
14-8