![background image](http://html1.mh-extra.com/html/daelim/a-four/a-four_service-manual_3154895058.webp)
5-6
FUEL SYSTEM
AIR GUN
CARBURETOR PASSAGES CLEANING
●
Disassemble all component parts of carburetor and
then clean the air and fuel passages of carburetor body
with compressed air.
•
Do not use it wire, otherwise the carburetor body and
fuel pump get damaged.
●
Assemble in the reverse order of disassembly.
•
Be sure to install the needle jet with the smaller hole
toward the float chamber.
•
Install the air screw and its O-ring and washer in the
order as shown in the drawing. If the air screw and
carburetor body are replaced with the new ones,
adjustment is necessary.
•
Do not fasten it strongly, otherwise the face of seat
get damaged.
CARBURETOR INSPECTION
●
Connect an ohmmeter to the auto bystarter wire
connector terminals and measure the resistance. If the
resistance is greatly out of specification, it indicates a
faulty PTC in the auto bystarter. Replace the auto
bystarter.
RESISTANCE:4.0
Ω±
1
Ω
(20 C)
•
The auto by starter might be normal if the resistance
is only slightly out of specification. However, be sure
to check all related parts for trouble.
●
Remove the carburetor and let it cool down for 30
minutes. Insert a vinyl tube into the fuel increasing
circuit and blow into the tube.
●
Air should flow into the circuit.
●
If air does not flow into the circuit, replace the auto
bystarter.
Summary of Contents for A-FOUR -
