DAELIM A-FOUR -, Service Manual

Page: 146 / 186

HEADLIGHT VOLTAGE INSPECTION
●
Remove the front cover.
( 3-5)
·
Check voltage with the headlight coupler connected.
●
After starting the engine, place the dimmer switch to
HI and check the voltage between the blue (+) and
green (-) wires of the headlight coupler.
·
Measurement is performed in AC area.
CONTROL VOLTAGE : 12.6~13.6V/5,000rpm
●
If voltage is incorrect, check the regulator/rectifier.
REGULATOR/RECTIFIER INSPECTION
HARNESS CIRCUIT INSPECTION
●
Remove the front cover.
( 3-5 )
●
Remove the 4P coupler of the regulator/rectifier and
inspect the wiring circuit in the main harness side
terminal.
REGULATOR/RECTIFIER INSPECTION
●
If the inspection of the harness side proves to be
satisfactory, check the regulator/rectifier coupler for
faulty connection, and measure the resistance between
the terminals of the regulator/rectifier.
13-6
CHARGING SYSTEM/A.C.GENERATOR
REGULATOR RECTIFIER COUPLER
ITEM
BATTERY WIRE
CHARGING
COIL
LIGHTING
COIL
Voltage between red “
⊕
” and green “
⊖
”.
※
Resistance between white wire and
earth wires. Disconnect the starter.
※
Resistance between yellow wire and
earth wires. Disconnect dimmer
switch connection
Damaged, disconnected main fuse/harness.
AC generator (charging, lighting coil
coupler connection damage) resister(6.7
Ω
5W) headlight lighting circuit.
There must be battery voltage.
0.4~1.0
Ω
(20
℃
)
0.2~0.8
Ω
(20
℃
)
MEASUREMENT LOCATION LEVEL AREAS OF INSPECTION IF INCORRECT
A L B E
A
∞
3-50
∞
L
∞ ∞
5-100
B
∞ ∞ ∞
E
∞
5-100
∞
Inspect
※
part after at least 10 minutes later.
RESISTANCE VALUE
Tester
⊕
Tester
⊖
(
20
℃
) Unit :
(BATEERY TERMINAL)
TERMINAL ARRANGEMENT
(LAMP TERMINAL)
(EARTH TERMINAL) (CHARGING TERMINAL)