Razor UB1 Replacement Procedure Download

Page: 1 / 3

Need Help?

Visit our website at

www.razor.com

or call toll-free at

866-467-2967

Monday - Friday 8:00am - 5:00pm Pacific Time.

WARNING

Step 1

Step 2

Required Tools: (Not included)

A. Phillips screwdriver

B. 2 mm Allen wrench

C. Flat screwdriver

CAUTION:

To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove five (5) screws from

the battery cover on the charger port side.

Remove two (2) more screws from the other side of the

battery cover. Remove battery cover and set aside.

UB1 THROTTLE - REPLACEMENT PROCEDURE

PART # W15127016043

Summary of Contents for UB1

Page 1: ...al shock or other injury turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures Failure to follow these steps in the correct order may cause irreparable...

Page 2: ...keep the cables together Be careful do not cut the cables Using a 2 mm Allen wrench loosen the set screw from the throttle and slide throttle away from the grip Locate and disconnect the throttle fro...

Page 3: ...rom the T tube Reverse the steps ATTENTION Charge battery 5 hours before using Using a long wire or shoelace tape one end to throttle wire end that connects to controller Pull the wire from the handle...