D-Link xStack, Reference Manual

Page: 608 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
603
max_rtr_adv_interval - Specifies the maximum time allowed between sending unsolicited
multicast Router Advertisements from the interface, in seconds. It must be no less than 4
seconds and no greater than 1800 seconds. The default is 600 seconds.
<sec 4-1800> - Enter the time between 4 and 1800 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the RA state as enabled and the life_time of the “tiberius” interface to be 1000
seconds:
DGS-3620-28SC:admin#config ipv6 nd ra ipif tiberius state enable life_time 1000
Command: config ipv6 nd ra ipif tiberius state enable life_time 1000
Success.
DGS-3620-28SC:admin#
49-6 config ipv6 nd ra prefix_option ipif
Description
This command is used to configure the prefix option for the router advertisement function.
Format
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time
<sec 0-4294967295> | valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]}(1)
Parameters
<ipif_name 12> - Enter the name of the interface. The maximum length is 12 characters.
<ipv6networkaddr> - Enter the IPv6 network address.
preferred_life_time - Specifies the number in seconds that an address, based on the specified
prefix using the stateless address configuration, remains in preferred state.
<sec 0-4294967295> - Enter the time between 0 and 4294967295 seconds. For an infinite
valid lifetime the value can be set to 4294967295.
valid_life_time - Specifies the number of seconds that an address, based on the specified prefix,
using the stateless address configuration, remains valid.
<sec 0-4294967295> - Enter the time between 0 and 4294967295 seconds. For an infinite
valid lifetime the value can be set to 4294967295.
on_link_flag - Specifies to enable or disable the function.
enable - Setting this field to enable will denote, within the IPv6 packet, that the IPv6 prefix
configured here is assigned to this link-local network. Once traffic has been successfully
sent to these nodes with this specific IPv6 prefix, the nodes will be considered reachable
on the link-local network.
disable - When set to disable, the addresses implied by the specified prefix are not available
on the link where the RA message is received.
autonomous_flag - Specifies to enable or disable the function.
enable - Setting this field to enable will denote that this prefix may be used to autoconfigure
IPv6 addresses on the link-local network.