xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1236
Appendix A
Password Recovery
Procedure
This chapter describes the procedure for resetting passwords on D-Link switches. Authenticating
any user who tries to access networks is necessary and important. The basic authentication
method used to accept qualified users is through a local login, utilizing a Username and Password.
Sometimes, passwords get forgotten or destroyed, so network administrators need to reset these
passwords. This chapter explains how the Password Recovery feature can help network
administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily
recover passwords.
Complete these steps to reset the password:
•
For security reasons, the Password Recovery feature requires the user to physically access
the device. Therefore this feature is only applicable when there is a direct connection to the
console port of the device. It is necessary for the user needs to attach a terminal or PC with
terminal emulation to the console port of the switch.
•
Power on the switch. After the runtime image and UART init are loaded to 100%, the switch
will allow 2 seconds for the user to press the hotkey [^] (Shift + 6) to enter the “Password
Recovery Mode.” Once the switch enters the “Password Recovery Mode,” all ports on the
switch will be disabled and all port LEDs will be lit.
Boot Procedure V1.00.016
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100%
MAC Address : 00-03-38-10-28-01
H/W Version : B1
Please Wait, Loading V2.50.014 Runtime Image .............. 100 %
UART init ................................................. 100 %
Password Recovery Mode
>
•
In the “Password Recovery Mode” only the following commands can be used.
Command
Parameters
reset config
{force_agree}
The
reset config
command resets the whole configuration back to the
default values.
force_agree
– Specify to forcibly agree with the command.
reboot
{force_agree}
The
reboot
command exits the Reset Password Recovery Mode and
restarts the switch. A confirmation message will be displayed to allow the
user to save the current settings.
Summary of Contents for xStack
