D-Link xStack, Reference Manual

Page: 172 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
167
Chapter 12 Digital Diagnostic
Monitoring (DDM) Commands
config ddm [trap | log] [enable | disable]
config ddm ports [<portlist> | all] [[temperature_threshold {high_alarm <degrees> | low_alarm
<degrees> | high_warning <degrees> | low_warning <degrees>} | voltage_threshold
{high_alarm <voltage> | low_alarm <voltage> | high_warning <voltage> | low_warning
<voltage>} | bias_current_threshold {high_alarm <milliampere> | low_alarm <milliampere> |
high_warning <milliampere> | low_warning <milliampere>} | tx_power_threshold {high_alarm
<mw_or_dbm> | low_alarm <mw_or_dbm> | high_warning <mw_or_dbm> | low_warning
<mw_or_dbm>} | rx_power_threshold {high_alarm <mw_or_dbm> | low_alarm <mw_or_dbm>
| high_warning <mw_or_dbm> | low_warning <mw_or_dbm>}] | {state [enable | disable] |
shutdown [alarm | warning | none]}]
show ddm
show ddm ports
{<portlist>} [status | configuration]
config ddm power_unit [mw | dbm]
12-1 config ddm
Description
The command configures the DDM log and trap action when encountering an exceeding alarm or
warning thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap - Specifies whether to send traps, when the operating parameter exceeds the corresponding
threshold. The DDM trap is disabled by default.
log - Specifies whether to send a log, when the operating parameter exceeds the corresponding
threshold. The DDM log is enabled by default.
enable - Specifies to enable the log or trap sending option.
disable - Specifies to disable the log or trap sending option.
Restrictions
Only Administrator, and Operator level users can issue this command.
Example
To configure DDM log state to enable: