D-Link xStack, Reference Manual

Page: 598 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
593
Format
config ip_tunnel isatap <tunnel_name 12> {ipv6address <ipv6networkaddr> | source
<ipaddr>}(1)
Parameters
<tunnel_name 12> - Enter the IP tunnel interface name used here. This name can be up to 12
characters long.
ipv6address - (Optional) Specifies the IPv6 address assigned to this IPv6 tunnel interface. IPv6
processing will be enabled on the IPv6 tunnel interface when an IPv6 address is configured.
The last 32 bits of the IPv6 ISATAP address correspond to an IPv4 address assigned to the
tunnel source.
<ipv6networkaddr> - Enter the IPv6 address used here.
source - (Optional) Specifies the source IPv4 address of this IPv6 tunnel interface. It is used as
the source address for packets in the IPv6 tunnel. The tunnel destination IPv4 address is
extracted from the last 32 bits of the remote tunnel endpoint’s IPv6 ISATAP address.
<ipaddr> - Enter the source IPv4 address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To configure an IPv6 ISATAP tunnel (Tunnel name is “tn2”, Tunnel source IPv4 address is
10.0.0.1, Tunnel IPv6 address is 2001::5efe:a00:1/64):
DGS-3620-28SC:admin# config ip_tunnel isatap tn2 source 10.0.0.1
Command: config ip_tunnel isatap tn2 source 10.0.0.1
Success.
DGS-3620-28SC:admin# config ip_tunnel isatap tn2 ipv6address
2001::5efe:a00:1/64
Command: config ip_tunnel isatap tn2 ipv6address 2001::5efe:a00:1/64
Success.
DGS-3620-28SC:admin#
48-6 show ip_tunnel
Description
This command is used to show one or all IP tunnel interfaces’ information.
Format
show ip_tunnel {<tunnel_name 12>}