D-Link xStack, Reference Manual

Page: 1158 / 1284

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1153
<pathname> - Enter an absolute path name on the device.
Restrictions
Only Administrator-level users can issue this command.
Example
To download runtime firmware from a TFTP server:
DGS-3620-28SC:admin#download firmware_fromTFTP 10.0.0.66 src_file dgs-3620.had
dest_file runtime.had
Command: download firmware_fromTFTP 10.0.0.66 src_file dgs-3620.had dest_file
runtime.had
Connecting to server................... Done.
Download firmware...................... Done. Do not power off!
Please wait, programming flash......... Done.
DGS-3620-28SC:admin#
110-2 download cfg_fromRCP
Description
This command is used to download a configuration file from a Remote Copy Protocol (RCP) server.
Format
download cfg_fromRCP [{username <username>} {<ipaddr>} src_file <path_filename 64> |
rcp: <string 128>] {[unit <unit_id 1-12> | all]} {dest_file <pathname>}
Parameters
username - (Optional) Specify the remote user name on the RCP server.
<username> - Enter the remote user name on the RCP server.
<ipaddr> - (Optional) Specify the IP address of the RCP server.
src_file - Specifies the path and file name of the switch configuration file on the RCP server. The
maximum length is 64.
<path_filename 64> - Enter the path and file name of the switch configuration file on the RCP
server. The maximum length is 64.
rcp: - Syntax: rcp: username@ipaddr/directory/filename. Example for full path:
user_name@10.1.1.1/home/user_name/desxxxx.had; Example for relative path:
user_name@10.1.1.1./desxxxx.had. Note: No spaces in the whole <string>.
<string 128> - Syntax: rcp: username@ipaddr/directory/filename. Example for full path:
user_name@10.1.1.1/home/user_name/desxxxx.had; Example for relative path:
user_name@10.1.1.1./desxxxx.had. Example for omitted user name in RCP string:
10.1.1.1./desxxxx.had. Note: No spaces in the whole <string>.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id 1-12> - Enter the unit ID used here. This value must be between 1 and 12.
all - Specifies that all the units in the stacking system will be used.
dest_file - (Optional) Specify the path and file name of the destination file on the device.
<pathname> - Enter the path and file name of the destination file.