D-Link NetDefend DFL-1660, User Manual

Page: 227 / 595

4.6. Multicast Routing
4.6.1. Overview
The Multicast Problem
Certain types of Internet interactions, such as conferencing and video broadcasts, require a single
client or host to send the same packet to multiple receivers. This could be achieved through the
sender duplicating the packet with different receiving IP addresses or by a broadcast of the packet
across the Internet. These solutions waste large amounts of sender resources or network bandwidth
and are therefore not satisfactory. An appropriate solution should also be able to scale to large
numbers of receivers.
The Multicast Routing Solution
Multicast Routing solves the problem by the network routers themselves, replicating and forwarding
packets via the optimum route to all members of a group.
The IETF standards that allow multicast routing are the following:
• Class D of the IPv4 address space which is reserved for multicast traffic. Each multicast IP
address represent an arbitrary group of recipients.
• The Internet Group Membership Protocol (IGMP) allows a receiver to tell the network that it is
a member of a particular multicast group.
• Protocol Independent Multicast (PIM) is a group of routing protocols for deciding the optimal
path for multicast packets.
Underlying Principles
Multicast routing functions on the principle that an interested receiver joins a group for a multicast
by using the IGMP protocol. PIM routers can then duplicate and forward packets to all members of
such a multicast group, thus creating a distribution tree for packet flow. Rather than acquiring new
network information, PIM uses the routing information from existing protocols, such as OSPF, to
decide the optimal path.
Reverse Path Forwarding
A key mechanism in the multicast routing process is Reverse Path Forwarding. For unicast traffic, a
router is concerned only with a packet's destination. With multicast, the router is also concerned
with a packets source since it forwards the packet on paths which are known to be downstream,
away from the packet's source. This approach is adopted to avoid loops in the distribution tree.
Routing to the Correct Interface
By default, multicast packets are routed by NetDefendOS to the core interface (in other words, to
NetDefendOS itself). SAT Multiplex rules are set up in the IP rule set in order to perform forwarding
to the correct interfaces. This is demonstrated in the examples described later.
Note: Interface multicast handling must be On or Auto
For multicast to function with an Ethernet interface on any NetDefend Firewall, that
interface must have multicast handling set to On or Auto. For further details on this
4.6. Multicast Routing Chapter 4. Routing
227