D-Link DWS-1008 User Manual
Hardware Overview (Front Panel)
Console Port:
The serial console port provides a direct management connection to a DWS-1008 switch’s
command-line interface (CLI). The port has a DB-9 female connector and supports the
EIA-232D signaling standard.
Ethernet Ports (1-6):
The 10/100 Ethernet ports on the DWS-1008 switch provide automatic MDI/MDX, which automatically
crosses over the send and receive signals if required. Ports 1-6 support PoE.
Uplink Ports (7 & 8):
Ports 7 and 8 on the DWS-1008 switch are uplink ports only and do not support PoE.
LEDS:
Link (1-8):
Solid green
100Mbps link is operational.
Solid amber
10Mbps link is operational.
Blinking green
Traffic is active on the 100Mbps link.
Blinking amber
Traffic is active on the 10Mbps link.
AP (1-6):
Solid green
For an DWL-8220AP’s active link, with PoE enabled, all the following
are true:
• Access point has booted.
• Access point has received a valid configuration from the switch.
• Management link with an access point is operational.
Alternating green Access point is booting with an image received from the switch.
and amber
If the LED remains in this state indefinitely, the boot or configuration
attempt has failed.
Solid amber
PoE is on but no access point is connected to the link.
Blinking amber
Access point is not connected or is unresponsive, or there is a PoE
problem.
Unlit
Port is not configured as an AP access port, or PoE is off.
Summary of Contents for DWS-1008
Page 1: ......
