D-Link DWS-1008 User Manual
1
Disabling 802.1X Authentication for WPA
To disable 802.1X authentication for WPA clients, use the following command:
set service-profile
name
auth-dot1x {enable | disable}
Note: This command does not disable 802.1X authentication for non-WPA clients.
To disable WPA authentication in service profile
wpa
, type the following command:
DWS-1008#
set service-profile wpa auth-dot1x disable
success: change accepted.
Displaying WPA Settings
To display the WPA settings in a service profile, use the following command:
show service-profile {
name
| ?}
To display the WPA settings in effect in service profile
wpa
, type the following command:
DWS-1008#
show service-profile sp1
ssid-name: private
ssid-type: crypto
Beacon: yes
Proxy ARP: no
DHCP restrict: no
No broadcast: no
Short retry limit: 5
Long retry limit: 5
Auth fallthru: none
Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page:
Custom agent-di rectory:
Static COS: no
COS: 0
CAC mode: none
CAC sessions: 14
User idle timeout: 180
Idle client probing: yes
Keep initial vlan: no
Web Portal Session Timeout: 5
Web Portal ACL: <none>
WEP Key 2 value: <none>
WEP Key 1 value: <none>
WEP Key 4 value: <none>
WEP Key 3 value: <none>
WEP Multicast Index: NO
WEP Unicast Index:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 30000ms
11a beacon rate: 6.0
multicast rate: AUTO
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate: 2.0
multicast rate: AUTO
11b mandatory rate: 1.0,2.0
standard rates: 5.5,11.0
11g beacon rate: 2.0
multicast rate: AUTO
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0, 36.0,48.0,54.0
The WPA settings appear at the bottom of the output.
Note: The WPA fields appear in the show service-profile output only when WPA is enabled.
Summary of Contents for DWS-1008
Page 1: ......