D-Link DWS-1008 User Manual
Displaying HTTPS Information
To display HTTPS service information, use the following command:
show ip https
To display information for a switch’s HTTPS server, type the following command:
DWS-1008>
show ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address Last Connected
Time
Ago(s)
----------------------------------------------------------------------------------
10.10.10.56 2003/05/09
15:51:26 pst
349
The command lists the TCP port number on which the switch listens for HTTPS connections. The
command also lists the last 10 devices to establish HTTPS connections with the switch and when the
connections were established.
If a browser connects to a switch from behind a proxy, then only the proxy IP address is shown. If
multiple browsers connect using the same proxy, the proxy address appears only once in the output.
Changing the Idle Timeout for CLI Management
Sessions
By default, MSS automatically terminates a console or Telnet session that is idle for more than one hour.
To change the idle timeout for CLI management sessions, use the following command:
set system idle-timeout
seconds
You can specify from 0 to 86400 seconds (one day). The default is 3600 (one hour). If you specify 0,
the idle timeout is disabled. The timeout interval is in 30-second increments. For example, the interval
can be 0, or 30 seconds, or 60 seconds, or 90 seconds, and so on. If you enter an interval that is not
divisible by 30, the CLI rounds up to the next 30-second increment. For example, if you enter 31, the
CLI rounds up to 60.
This command applies to all types of CLI management sessions: console, Telnet, and SSH. The timeout
change applies to existing sessions only, not to new sessions.
The following command sets the idle timeout to 1800 seconds (one half hour):
DWS-1008#
set system idle-timeout 1800
success: change accepted.
Summary of Contents for DWS-1008
Page 1: ......
