D-Link DWS-1008 User Manual
You can configure the DHCP client on more than one VLAN, but the client can be active on only one
VLAN.
To remove all IP information from a VLAN, including the DHCP client and user-configured DHCP server,
use the following command:
clear interface
vlan-id
ip
The IP interface table flags the address assigned by a DHCP server with an asterisk ( * ). In the following
example, VLAN corpvlan received IP address 10.3.1.110 from a DHCP server.
DWS-1008#
show interface
* = From DHCP
VLAN
Name
Address
Mask
Enabled
State RIB
--------------------------------------------------------------------------------------------------------------------------
4
corpvlan
*10.3.1.110
255.255.255.0
YES
Up
ipv4
Displaying DHCP Client Information
To display DHCP client information, type the following command:
DWS-1008#
show dhcp-client
Interface:
corpvl an (4)
Configuration Status: Enabled
DHCP State:
IF_UP
Lease Allocation:
65535 seconds
Lease Remaining:
65532 seconds
IP Address:
10.3.1. 110
Subnet Mask:
255.255.255.0
Default Gateway:
10.3.1.1
DHCP Server:
10.3.1.4
DNS Servers:
10.3.1. 29
DNS Domain Name:
mycorp .com
Disabling or Reenabling an IP Interface
IP interfaces are enabled by default. To administratively disable or reenable an IP interface, use the
following command:
set interface
vlan-id
status {up | down}
Removing an IP Interface
To remove an IP interface, use the following command:
clear interface
vlan-id
ip
Caution: If you remove the IP interface that is being used as the system IP address, features that
require the system IP address will not work correctly.
Summary of Contents for DWS-1008
Page 1: ......
