D-Link DWS-1008, Product Manual, Page: 233 / 502

D-Link DWS-1008 User Manual 1
2. Configure a backbone VLAN and verify the configuration change. Type the following commands:
DWS-1008#
set vlan 10 name backbone port 7-8
success: change accepted.
DWS-1008#
show vlan config
Admin VLAN Tunl
VLAN Name Status State Affin Port Tag Port State
----------------------------------------------------------------------------------------------------------------------------
1 default --- Up --- --- --- ---
1 none Up
10 backbone Up Down 5
7 none Down
8 none Down
3. Enable STP on the backbone VLAN and verify the change. Type the following commands:
DWS-1008#
set spantree enable vlan backbone
success: change accepted.
DWS-1008#
show spantree vlan 10
VLAN 10
Spanning tree mode PVST+
Spanning tree type IEEE
Spanning tree enabled
Designated Root 00-0b-0e-00-04-0c
Designated Root Priority 32768
Designated Root Path Cost root 0
Root Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Bridge ID MAC ADDR 00-0b-0e-00-04-0c
Bridge ID Priority 32768
Bridge Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Port Vlan STP-State Cost Prio Portfast
-------------------------------------------------------------------
7 10 Disabled 4 128 Disabled
8 10 Disabled 4 128 Disabled