Cyclades AlterPath Manager 2500, Installation, Configuration And User Manual

Page: 122 / 368

First Time Configuration Wizard
90 APM Installation, Configuration, and User’s Guide
• Select a time zone
• Enter a new system date and time (format is MM/DD/YY)
Note: You must type a date, even if it is the same as the date displayed, in
order to change the time.
• Enter the time (if you did not select the default date: format is
HH:MM)
• Select (Y)es or (N)o for Enable Ethernet Bonding. (see example on
page 96 for
no and example on page 279 for yes ).
• Select (S)tatic, (D)HCP, (N)one, or (K)eep for the Ethernet 0 (eth0) IP
address
• Enter the eth0 IP address (if you selected static)
Note: When you are connecting to a public network (see Figure 2-2, “Single
Network Diagram” on page 28), Eth0 can be configured with 2 IP addresses
as long as both addresses conform to the subnet and address range of the
public LAN.
• Enter the eth0 subnet mask address
• Select (S)tatic, (N)one, or (K)eep for the eth1 IP address
• Enter the eth1 IP address (if you selected static)
Note: When you are connecting to a private network (see Figure 2-1,
“Private Network Diagram” on page 27), Eth0 (the primary Ethernet port) is
connected to the public LAN. The Eth0 address and subnet must conform to
the public LAN’s subnet and address range. Eth1 (the secondary Ethernet
port) is connected to the private LAN with its own subnet and address range.
• Enter the secondary Ethernet subnet mask address
• Configure Ethernet subinterfaces (Y)es, (N)o, or (L)ist
• Configure Ethernet VLANs (Y)es, (N)o, or (L)ist
• Enter Ethernet default gateway
• Set Ethernet eth0 speed/duplex