6
General information
Note: This manual is for the AMS family of products including the AMS-300C, AMS-200C, AMS-150C and AMRS
WaferSense and ReticleSense Device and Link
Changes or modifications not expressly approved by CyberOptics Corporation, may void your authority to operate
the AMS device.
The radio contained in the AMS meets all the applicable FCC requirements for RF Safety. While in operation, the
FCC requires users and nearby persons to maintain a minimum separation distance of 20 cm (8 inches) or farther
from the AMS.
The AMS and Link have been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
General
Information
