29
3)
Place the AMS device in the charging case (see
Opening and Closing the Charging Case
on page
the lid.
4)
Plug the charger line adapter into a 100 VAC to 240 VAC mains, and plug the other end into the charging case
connection on the right side of the charging case.
The charging case is air-tight. After air transport it may be necessary to relieve the pressure differential in
order to open the case. To do so, loosen the
Pressure Relief Vent
screw until air enters the case. Then re-
tighten the screw.
5)
When power is applied to the charging case, the
Charger on
LED will light and the
Charging
LED will also light,
unless the unit is already fully charged. In addition, the
Unit on
LED will light. If the unit is still paired to a
powered link box, the
Connect/ Pair
LED will light.
6)
Charge the unit until the
Charging
LED goes dark. The unit is now fully charged and ready for data collection.
However, the unit can be used if not fully charged.
7)
The AMS can remain in the charging case with power applied to the case even when fully charged. The battery
will not be damaged. The AMS should be stored in the sealed charging case when not in use.
