CTC Union FRM220-NMC, User Manual, Page: 92 / 182

Appendix A
90
A.2.19.7 Configuring SNMP Traps
A trap is a type of PDU (Protocol Data Unit) used to report an alert or other asynchronous event about a
managed subsystem. Traps are unsolicited messages sent by the agent to the network management software.
They may be a system specifically generated message or they could be programmed through the Alarm
Management, see section 3.3.2.
The only configuration done here for traps is to enter the trap destination IP address. From the SNMP Manager
menu, select <N> (Go to Trap Configuration Menu).
This SNMP agent supports up to eight (8) SNMP trap receivers that can be entered into this configuration menu.
In the above example, the SNMP network manager at 59.125.162.247 IP will receive traps.
*********************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220-1000EAS Ver:3.240 ***
*********************************************
<< Trap Configuration Setup >>
Trap Receiver IP Community String
================ ================
#1 --- ---
#2 --- ---
#3 --- ---
#4 --- ---
#5 --- ---
#6 --- ---
#7 --- ---
#8 --- ---
<1>~<8>:Edit Trap Receiver #1 to #8 Settings.
<D> :Delete All Settings.
<ESC> :Go to Manager Configuration Menu.
*********************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220-1000EAS Ver:3.240 ***
*********************************************
<< Trap Configuration Setup >>
Trap Receiver IP Community String
================ ================
#1 59.125.162.247 secret
#2 --- ---
#3 --- ---
#4 --- ---
#5 --- ---
#6 --- ---
#7 --- ---
#8 --- ---
<1>~<8>:Edit Trap Receiver #1 to #8 Settings.
<D> :Delete All Settings.
<ESC> :Go to Manager Configuration Menu.