CTC Union FRM220-NMC, User Manual, Page: 150 / 182

Appendix A
148
A.7.23 Advanced Functions
The 10/100A has several sets of pre-defined 'advanced functions' which allow the user to quickly configure the
switch for specific applications. Each of these is shown below and will be explained in detail.
<0>
Normal : This is the default mode of the 10/100A . In this mode the unit is simply a 4 port managed media
converter/switch.
<1>
Port 1 to Port 2 Mirror : The mirror mode provides fiber aggregation or 'trunking'. It uses one or two fiber lines to
achieve this feature. The application drawing for this mode is shown in section 3.5.1.
<2>
Port VLAN(1/3; 2/4) : This function will allow the media converter/switch to act like two separate gigabit media
converters. By using port based VLAN, traffic is isolated between the port pairs 1 and 3 and 2 and 4. The application drawing
for this mode is shown in section 3.5.2. (This function is only available in the dual fiber model.)
<3>
Port 1 and Port 2 Redundancy : This function provides a fiber redundancy so that if either fiber path losses transmission,
the other path is a backup. The application drawing for this mode is shown in section 3.5.3. (This function is only available in
the dual fiber model.)
<4>
Static 802.1Q VLAN : This mode will open up the unit to further settings for 802.1Q VLAN settings. This mode's
application drawing and details are shown in section 3.5.4.
<5>
Static 802.1Q VLAN & Port 1/2 Redundancy : (on 10/100AS-2 model only) This special mode combines fiber port
redundancy with tagged VLAN. The application drawing and details for this mode are shown in section 3.5.5.
<6>
Spanning Tree Protocol : The Spanning tree protocol (STP) is a link layer network protocol that ensures a loop-free
topology for any bridged LAN. Use this protocol when setting up the converter/switch in ring or mesh topologies. The
application drawing and details for this mode are shown in section 3.5.6.
*************************************************
*** CTC UNION TECHNOLOGIES CO., LTD. ***
*** FRM220-10/100AS-2 ver:3.016 ***
*************************************************
<< Local Device Status and Configuration >>
<1> :Pause Frame [Disable]
<2> :Advance Functions [Normal ]
<3> :Maximum OAMPDUs Size (60 ~ 1518 Octets) [1500]
<4> :Accept Remote H/W Reset [Disable]
<5> :UPNP [Disable]
<A> :Remote A H/W Reset.
<B> :Remote B H/W Reset.
<L> :Load Default Settings and Write to System.
<R> :System Reboot.
_______________________________________________________________
Select Advance Functions.
<0> Normal <1> Port 1 to Port 2 Mirror
<2> Port VLAN(1/3; 2/4) <3> Port 1 and Port 2 Redundancy
<4> Static 802.1Q VLAN <5> Static 802.1Q VLAN & Port 1/2
Redundancy
<6> Spanning Tree Protocol
<ESC>:Previous Menu.