CTC Union FRM220-NMC, User Manual, Page: 108 / 182

Appendix A
106
Serial Line Card Detail
The following is the display screen for the Serial fiber converter.
Slot #05 SERIAL Select Menu:
Select Menu:
1: Local Setting
2: Remote Setting
Command Function Key:
'1' to '2': Select Menu
'ESC': Main Menu
The Serial card supports remote management features; Select 1 or 2.
Slot #05 SERIAL Card Status:
Data In Status >> Mark << H/W Version: 1.0
Fiber >> Link Up << F/W Version: 1.0
Test LED >> Off <<
Card Parameter Setup Menu:
0: Channel Enable/Disable >> Enable <<
1: Far End Fault Setting >> Disable <<
2: Port Reset >> Disable <<
3: Mode Setting >> RS-232 3 Wire <<
4: SERIAL Termination >> Disable <<
5: Fiber Loop-Back test >> Off <<
6: Reset Channel Setting to Default
Command Function Key:
'0' to '4': Toggle I/O Card Settings
'5' to '6': I/O Card Commands
'R': Refresh Status
'ESC': Previous Menu
The following are descriptions of the function keys available and the actions which they perform.
0 : This key toggles the channel enable/disable and can be used to halt transmission on this line card to the
remote cpe side.
1 : This key toggles the FEF setting enabled or not.
2 : This key toggles the Port Reset.
3 : This key toggles between the different mode settings for RS-232,485, and 423.
4 : This key toggles the setting of termination for the serial interface lines.
5 : This key initiates the fiber remote loop back test.*
6 : This key will reset the card settings to factory default.
R : This key will refresh the screen display.
ESC : This key will leave the card setting menu.
* During loop back tests, normal traffic is interrupted.