Covidien Nellcor OxiMax N-600x, Operator'S Manual

Page: 86 / 146

Managing Oximetry Data
80
Operator’s Manual
6. Press the SELECT softkey.
Note:
When SPD is enabled, the Clinical and SPDout protocols include SPD information. Results
cannot be predicted for host systems without upgrades to support the extra SPD
information. See Table 10:
Communication Protocol Compatibility and Output , on page 79.
7. Press the ADJUST UP or ADJUST DOWN keys below the ALARM SILENCE key on the
oximeter panel to select the desired baud rate, should it differ from the default for that
particular protocol.
8. Press the EXIT softkey.
Data Output Information
Printing Oximeter Trend Data
Refer to the Service Manual or contact Nellcor's Technical Services Department at
1.800.635.5267, or your local Nellcor representative.
Real-Time Output
Real-time data is continuously sent to the data port on the back of the oximeter.
Patient data can be obtained through the data port by connecting the oximeter data
port to a PC or serial printer. When real-time output is being transmitted to a printer
or PC, a new line of data displays every second. Column headings display or print
after every 25 lines, or if one of the values in the column heading changes. Readings
display at one-second intervals.
Note:
If the data output stops transmitting, turn the power off and back on again or, if the oximeter
is connected to a PC, send an XON (Ctrl-q) command to reset the oximeter.