Cosen AH-250H, Instruction Manual

Page: 45 / 134

OPERATING INSTRUCTION
Section 4
4-12
13) Turn the insert knobs CW (clockwise) to tighten the inserts.
3. Adjust the position of the wire brush using the following procedures:
1) Loosen the blade cover.
2) Loosen the lock lever for the wire brush case.
3) Manually move the wire brush case so that the wire brush makes proper contact with the saw
blade.
NOTE: Please refer to section 7.3 for band saw cutting.
4) Install wire brush cover.
WARNING : DO NOT shovel chip while the saw band is running.
Ï
Wire Brush
Proper Improper
5) Tighten the lock lever and blade cover.
4. Close the covers of both the drive wheel and the driven wheel.
5. Properly position the blade guide according to the diameter (or the width) of the workpiece using
the following procedures:
1) Turn the left insert knob CCW (counterclockwise) to loosen the left insert.
2) Loosen the lock handle and manually move the blade guide. Align the indicator of the blade
guide with the scale on the guide slide in accordance with the size of the workpiece.
Page 45 Instruction Manual for AH-250H (B040) 04/12/2014